Wood floors are not just a focal point in the home; they are also a part of the family unit. They play an important role in every household and also add to its charm. But, over time, wood floors can get worn out and look ugly. There are different ways to repair them, but you need to be careful while dealing with Floor Sanding Melbourne issues so that you do not end up causing more damage than good.
Abnormal Gaps
Gaps between a wood floor and the wall can be caused by a number of things; consult Floor Sanding Melbourne expert to fill the gaps properly:
- The floor itself is uneven
- The floor has been damaged over time
- The installation was done poorly
Excessive Wear
The most common cause of excessive wear is using a sander that’s too aggressive. This can be true if you’re using the wrong grit of sandpaper, or if you’re not keeping the sander at a consistent angle.
The best way to avoid this issue is by practicing good technique when working with your power tools. Before starting any job, make sure that you thoroughly read over all instructions from the manufacturer and follow them to the letter. Take your time when doing this so that you don’t make any mistakes along the way.
If there are severe gaps in your flooring after sanding it down, it might not be possible for them to be repaired exactly as they were before hand; however, there are still options available for fixing these issues!
Sanding Blemishes
Once you have determined whether or not the blemish is a defect and needs to be sanded, you can begin to tackle it. If it is a stain, the best way to remove it is with a stain remover. These are available at most home improvement stores and are easy to apply.
Simply follow their instructions for use and make sure that you get all of the product on your floor before letting it dry completely. Then vacuum up any excess so that no residue remains in the cracks between boards.
If your blemish is actually a defect such as chipping or peeling paint or varnish, then you will need to do some more work in order to fix it properly. You should start by going over the affected area with an orbital sander using 100-grit paper until all traces of varnish or paint have been removed from around the chip/peel area (this can take several passes).
Then Floor Sanding Melbourne pad again with 150-grit paper both sides until smooth without creating new scratches; finish off by sanding lightly with 220-grit paper both sides as well until smooth without creating new scratches again – this will prime floor ready for painting if desired later on down the road.
In conclusion, we can see that there are some common mistakes to avoid while sanding and repairing gaps in your hardwood floors. The most important thing is to be careful when Floor Sanding Melbourne and repair the gaps, so you don’t damage your flooring by creating excessive wear or abrasion.
If you are dealing with abnormal flooring gaps, then just give a call at timber Floor Sanding Melbourne; our experts will be happy to help.
